3d_prints:instructions:conventional:step2
This is an old revision of the document!
Table of Contents
Step 2 – Install Reducer Base
New Parts needed for this step:
- Base
Step 2.1 –
In similar fashion as the gearbox, place the reducer assembly directly onto the base.
Step 2.2 –
Ensure the reducer assembly aligns with the base channels.
Step 2.3 – Slide to Lock
Push the reducer assembly straight to the right until it locks into place.
A slight amount of pressure pushing upwards from the underside of the base will help the reducer assembly slide.
3d_prints/instructions/conventional/step2.1773439274.txt.gz · Last modified: by unexpectedlee