3d_prints:instructions:conventional:step2
This is an old revision of the document!
Table of Contents
Step 2 – Install the Reducer Base
Place the reducer base onto the base and slide it to the back until it locks.
Step 2.1 – Position the Gearbox
Place the gearbox directly onto the reducer base.
Step 2.2 – Align the Guide Rails
Ensure the gearbox rails align with the reducer base channels.
Step 2.3 – Slide to Lock
Push the gearbox straight to the right until it locks into place.
Do not twist the gearbox while installing.
3d_prints/instructions/conventional/step2.1773186665.txt.gz · Last modified: by unexpectedlee