3d_prints:instructions:conventional:step10
This is an old revision of the document!
Table of Contents
Step 10 – Install Equalizer Beam
New Parts needed for this step:
- Equalize Pin
Step 10.1 – Part identification
The equalize pin is the last pin remaining.
Step 10.2 – Align tail bearing
Align the equalizer and tail bearing as shown.
Step 10.3 – Pin Install
Insert the equalize pin as shown.
Step 10.4 – Part completion
3d_prints/instructions/conventional/step10.1773508672.txt.gz · Last modified: by unexpectedlee