3d_prints:instructions:conventional:step1
This is an old revision of the document!
Table of Contents
Step 1 – Install the Gearbox
Place the gearbox onto the reducer base and slide it to the right until it locks.
Step 1.1 – Position the Gearbox
Place the gearbox directly onto the reducer base.
Step 1.2 – Align the Guide Rails
Ensure the gearbox rails align with the reducer base channels.
Step 1.3 – Slide to Lock
Push the gearbox straight to the right until it locks into place.
Be especially careful sliding the gear box forward. Horizontal twisting can break the rails.
3d_prints/instructions/conventional/step1.1773356193.txt.gz · Last modified: by unexpectedlee