====== Step 8 – Install Walking Beam  ======

<WRAP info>
New Parts needed for this step:
  - Saddle bearing pin
</WRAP>


===== Step 8.1 – Identify the part  =====

The saddle bearing pin is smaller than the equalizer pin but larger than the two equalizer arm pins.

{{:3d_prints:instructions:conventional:8a.jpg?700}}

-----

===== Step 8.2 – Walking beam install =====

Place the walking beam on the saddle bearing.  Insert the saddle bearing pin.

{{:3d_prints:instructions:conventional:8b.jpg?700}}

-----

===== Step 8.3 – Completed step =====

The saddle bearing pin should be centered in the saddle bearing.

{{:3d_prints:instructions:conventional:8c.jpg?700}}

-----
<WRAP group>
<WRAP quarter column>
[[3d_prints:instructions:conventional:step7|⬅ Previous Step]]
</WRAP>

<WRAP right quarter column>
[[3d_prints:instructions:conventional:step9|Next Step ➜]]
</WRAP>
</WRAP>