====== Step 7 – Install Horsehead  ======

<WRAP info>
New Parts needed for this step:
  - Horsehead
  - Walking Beam
</WRAP>


===== Step 7.1 – Identify parts  =====

The horsehead is on the left and walking beam on the right.

{{:3d_prints:instructions:conventional:7a.jpg?700}}

-----

===== Step 7.2 – Horsehead Alignment =====

Position the horsehead as shown on the walking beam.

{{:3d_prints:instructions:conventional:7b.jpg?700}}

-----

===== Step 7.3 – Slide Horsehead into position =====

Slide the horsehead onto the walking beam.

{{:3d_prints:instructions:conventional:7c.jpg?700}}

-----
<WRAP group>
<WRAP quarter column>
[[3d_prints:instructions:conventional:step6|⬅ Previous Step]]
</WRAP>

<WRAP right quarter column>
[[3d_prints:instructions:conventional:step8|Next Step ➜]]
</WRAP>
</WRAP>