====== Step 2 – Install Reducer Base  ======

<WRAP info>
New Parts needed for this step:
  - Base
</WRAP>

===== Step 2.1 – Position the reducer assembly  =====

In similar fashion as the gearbox, place the reducer assembly directly onto the base.

{{:3d_prints:instructions:conventional:2a.jpg?700}}

-----

===== Step 2.2 – Align the guide rails =====

Ensure the reducer assembly aligns with the base channels.

{{:3d_prints:instructions:conventional:2b.jpg?700}}

-----

===== Step 2.3 – Slide to Lock =====

Push the reducer assembly **straight to the right** until it locks into place.

<WRAP tip>
A slight amount of pressure pushing upwards from the underside of the base will help the reducer assembly slide.
</WRAP>

{{:3d_prints:instructions:conventional:2c.jpg?700}}

-----
<WRAP group>
<WRAP quarter column>
[[3d_prints:instructions:conventional:step1|⬅ Previous Step]]
</WRAP>

<WRAP right quarter column>
[[3d_prints:instructions:conventional:step3|Next Step ➜]]
</WRAP>
</WRAP>