====== Step 16 – Completed Unit  ======

<WRAP info>
New Parts needed for this step:
  - Gearbox Top
</WRAP>

===== Step 16.1 – Completed unit =====

Place the Gearbox Top on the Gearbox.

The unit is now completed.  If oriented as shown, the weights typically rotate in a clockwise manner.

{{:3d_prints:instructions:conventional:16a.jpg?700}}

-----
<WRAP group>
<WRAP quarter column>
[[3d_prints:instructions:conventional:step15|⬅ Previous Step]]
</WRAP>

<WRAP right quarter column>
[[3d_prints:instructions:conventional:step17|Next Step ➜]]
</WRAP>
</WRAP>