====== Step 14 – Install Motor Shaft  ======

<WRAP info>
New Parts needed for this step:
  - Motor Pulley
  - Motor Shaft
  - Hand Wheel
</WRAP>

===== Step 14.1 – Identify parts =====

Parts from left to right are:  Motor Pulley, Motor Shaft, and Hand Wheel.

{{:3d_prints:instructions:conventional:14a.jpg?700}}

-----

===== Step 14.2 – Insert motor shaft =====

Insert the motor shaft as shown.  The retaining ring should be on the right side.

{{:3d_prints:instructions:conventional:14b.jpg?700}}

-----

===== Step 14.3 – Install pulley =====

Install the pulley as shown.

{{:3d_prints:instructions:conventional:14c.jpg?700}}

-----

===== Step 14.4 – Install hand wheel =====

Install the handwheel as shown.

{{:3d_prints:instructions:conventional:14d.jpg?700}}

-----
<WRAP group>
<WRAP quarter column>
[[3d_prints:instructions:conventional:step13|⬅ Previous Step]]
</WRAP>

<WRAP right quarter column>
[[3d_prints:instructions:conventional:step15|Next Step ➜]]
</WRAP>
</WRAP>