====== Conventional Pumping Unit Assembly ======

{{:3d_prints:instructions:conventional:16a.jpg?700}}

This guide walks through assembling the conventional pumping unit model.

<WRAP important>
These instructions are still a work in progress.  Thanks for your patience.
</WRAP>

<WRAP box>
Estimated Time: 30 minutes

Required Tools: None

Optional Tools: Glue
</WRAP>
===== Assembly Steps =====

  * [[3d_prints:instructions:conventional:step1|Step 1 – Install Gearbox]]
  * [[3d_prints:instructions:conventional:step2|Step 2 – Install Reducer Base]]
  * [[3d_prints:instructions:conventional:step3|Step 3 – Install Gears]]
  * [[3d_prints:instructions:conventional:step4|Step 4 – Install Gear & Drive Shafts]]
  * [[3d_prints:instructions:conventional:step5|Step 5 – Install Motor & Motor Platform]]
  * [[3d_prints:instructions:conventional:step6|Step 6 – Install Posts]]
  * [[3d_prints:instructions:conventional:step7|Step 7 – Install Horsehead]]
  * [[3d_prints:instructions:conventional:step8|Step 8 – Install Walking Beam]]
  * [[3d_prints:instructions:conventional:step9|Step 9 – Install Pitman Arms]]
  * [[3d_prints:instructions:conventional:step10|Step 10 – Install Equalizer Beam]]
  * [[3d_prints:instructions:conventional:step11|Step 11 – Install Weights]]
  * [[3d_prints:instructions:conventional:step12|Step 12 – Install Crank Arms]]
  * [[3d_prints:instructions:conventional:step13|Step 13 – Install Wrist Pin ]]
  * [[3d_prints:instructions:conventional:step14|Step 14 – Install Motor Shaft ]]
  * [[3d_prints:instructions:conventional:step15|Step 15 – Install Belts ]]
  * [[3d_prints:instructions:conventional:step16|Step 16 – Completed Unit ]]
  * [[3d_prints:instructions:conventional:step17|Step 17 – Optional Step: Belt Guard ]]

-----
<WRAP right quarter column>
[[3d_prints:instructions:conventional:info|Information ➜]]
</WRAP>