OILMAN

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Step 10 – Install Equalizer Beam  ======

<WRAP info>
New Parts needed for this step:
  - Equalizer Pin
</WRAP>

===== Step 10.1 – Part identification =====

The equalize pin is the last pin remaining.

{{:3d_prints:instructions:conventional:10a.jpg?700}}

-----

===== Step 10.2 – Align tail bearing =====

Align the equalizer and tail bearing as shown.

{{:3d_prints:instructions:conventional:10b.jpg?700}}

-----

===== Step 10.3 – Pin Install =====

Insert the equalize pin as shown.

{{:3d_prints:instructions:conventional:10c.jpg?700}}

-----

===== Step 10.4 – Part completion =====

Push the pin in until it is centered.

{{:3d_prints:instructions:conventional:10d.jpg?700}}

-----
<WRAP group>
<WRAP quarter column>
[[3d_prints:instructions:conventional:step9|⬅ Previous Step]]
</WRAP>

<WRAP right quarter column>
[[3d_prints:instructions:conventional:step11|Next Step ➜]]
</WRAP>
</WRAP>