OILMAN

This page is read only. You can view the source, but not change it. Ask your administrator if you think this is wrong.

====== Conventional Pumping Unit Assembly ======

This guide walks through assembling the conventional pumping unit model.
<WRAP box>
Estimated Time: 30 minutes

Required Tools: None

Optional Tools: Glue
</WRAP>
===== Assembly Steps =====

  * [[prints:instructions:conventional_pumping_unit:step1_reducer_base|Step 1 – Install Reducer Base]]
  * [[prints:instructions:conventional_pumping_unit:step2_gearbox|Step 2 – Install Gearbox]]
  * [[prints:instructions:conventional_pumping_unit:step3_samson_post|Step 3 – Install Samson Post]]
  * [[prints:instructions:conventional_pumping_unit:step4_walking_beam|Step 4 – Install Walking Beam]]
  * [[prints:instructions:conventional_pumping_unit:step5_horsehead|Step 5 – Install Horsehead]]
  * [[prints:instructions:conventional_pumping_unit:step6_pitman_arms|Step 6 – Install Pitman Arms]]
  * [[prints:instructions:conventional_pumping_unit:step7_counterweights|Step 7 – Install Counterweights]]
  * [[prints:instructions:conventional_pumping_unit:step8_motor|Step 8 – Install Motor and Belt]]