Differences

This shows you the differences between two versions of the page.

--- prints:instructions:conventional:step1 [2026/03/10 23:42] – created unexpectedlee
+++ prints:instructions:conventional:step1 [2026/03/10 23:44] (current) – removed unexpectedlee
@@ Line 1: / Line 1: @@
-====== Step 1 – Install the Gearbox ======
-<WRAP box>
-Place the gearbox onto the reducer base and slide it to the right until it locks.
-</WRAP>
-===== Step 1.1 – Position the Gearbox =====
-Place the gearbox directly onto the reducer base.
-{{:3d_prints:conventional:1a.jpg?700}}
------
-===== Step 2.2 – Align the Guide Rails =====
-Ensure the gearbox rails align with the reducer base channels.
-{{:prints:gearbox_step2.jpg?700}}
------
-===== Step 2.3 – Slide to Lock =====
-Push the gearbox **straight to the right** until it locks into place.
-{{:prints:gearbox_step3.jpg?700}}
-<WRAP important>
-Do not twist the gearbox while installing.
-</WRAP>
------
-[[prints:instructions:conventional_pumping_unit:step1_reducer_base|⬅ Previous Step]]
-|
-[[prints:instructions:conventional_pumping_unit:step3_samson_post|Next Step ➜]]