Differences

This shows you the differences between two versions of the page.

--- 3dpprints:instructions:conventional:step2 [2026/03/10 23:48] – created unexpectedlee
+++ 3dpprints:instructions:conventional:step2 [2026/03/10 23:48] (current) – removed unexpectedlee
@@ Line 1: / Line 1: @@
-====== Step 1 – Install the Gearbox ======
-<WRAP box>
-Place the gearbox onto the reducer base and slide it to the right until it locks.
-</WRAP>
-===== Step 1.1 – Position the Gearbox =====
-Place the gearbox directly onto the reducer base.
-{{:3d_prints:instructions:conventional:1a.jpg?700}}
------
-===== Step 1.2 – Align the Guide Rails =====
-Ensure the gearbox rails align with the reducer base channels.
-{{:3d_prints:instructions:conventional:1b.jpg?700}}
------
-===== Step 1.3 – Slide to Lock =====
-Push the gearbox **straight to the right** until it locks into place.
-{{:3d_prints:instructions:conventional:1c.jpg?700}}
-<WRAP important>
-Do not twist the gearbox while installing.
-</WRAP>
------
-[[3d_prints:instructions:conventional:start|⬅ Previous Step]]
-|
-[[3dPprints:instructions:conventional:step2|Next Step ➜]]