3d_prints:instructions:conventional:step9
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| 3d_prints:instructions:conventional:step9 [2026/03/14 17:14] – [Step 9.5 –] unexpectedlee | 3d_prints:instructions:conventional:step9 [2026/03/14 22:00] (current) – [Step 9.1 – Identify parts] unexpectedlee | ||
|---|---|---|---|
| Line 13: | Line 13: | ||
| The pitman arm pins are the small cylinders on top. The equalize is in the middle flanked by pitman arms. The equalize and pins are bidirectional. | The pitman arm pins are the small cylinders on top. The equalize is in the middle flanked by pitman arms. The equalize and pins are bidirectional. | ||
| - | < | + | < |
| The upper pitman arms are obviously very thin. This part can be easily broken if care is not taken. | The upper pitman arms are obviously very thin. This part can be easily broken if care is not taken. | ||
| </ | </ | ||
3d_prints/instructions/conventional/step9.1773508453.txt.gz · Last modified: by unexpectedlee