Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step9 [2026/03/14 17:11] – unexpectedlee
+++ 3d_prints:instructions:conventional:step9 [2026/03/14 22:00] (current) – [Step 9.1 – Identify parts] unexpectedlee
@@ Line 13: / Line 13: @@
 The pitman arm pins are the small cylinders on top.  The equalize is in the middle flanked by pitman arms.  The equalize and pins are bidirectional.  The pitman arms are identical.
-<WRAP tip>
+<WRAP important>
-The upper pitman arms are obvious very thin.  This part can be easily broken if care is not taken.
+The upper pitman arms are obviously very thin.  This part can be easily broken if care is not taken.
 </WRAP>
@@ Line 33: / Line 33: @@
 -----
-===== Step 9.3 –  =====
+===== Step 9.3 – Correct orientation of pitman arm =====
-placeholder
+This step shows the correct orientation and alignment of one pitman arm.
 {{:3d_prints:instructions:conventional:9c.jpg?700}}
@@ Line 49: / Line 49: @@
 -----
-===== Step 9.5 –  =====
+===== Step 9.5 – Part completion =====
 Push the pins in until they are flush.