Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step9 [2026/03/12 01:26] – created unexpectedlee
+++ 3d_prints:instructions:conventional:step9 [2026/03/14 22:00] (current) – [Step 9.1 – Identify parts] unexpectedlee
@@ Line 1: / Line 1: @@
 ====== Step 9 – Install Pitman Arms  ======
-<WRAP box>
+<WRAP info>
-placeholder
+New Parts needed for this step:
+  - Pitman Arm Pins (2)
+  - Equalizer
+  - Pitman Arms (2)
 </WRAP>
-===== Step 9.1 –   =====
-placeholder
+===== Step 9.1 – Identify parts =====
+The pitman arm pins are the small cylinders on top.  The equalize is in the middle flanked by pitman arms.  The equalize and pins are bidirectional.  The pitman arms are identical.
+<WRAP important>
+The upper pitman arms are obviously very thin.  This part can be easily broken if care is not taken.
+</WRAP>
 {{:3d_prints:instructions:conventional:9a.jpg?700}}
@@ Line 13: / Line 21: @@
 -----
-===== Step 9.2 –  =====
+===== Step 9.2 – Place pitman arms =====
-placeholder
+Place one pitman arm on each side of the equalizer as shown.
+<WRAP tip>
+Though the pitman arms are identical, they do have a direction.  The side with the concave opening faces outward.
+</WRAP>
 {{:3d_prints:instructions:conventional:9b.jpg?700}}
@@ Line 21: / Line 33: @@
 -----
-===== Step 9.3 –  =====
+===== Step 9.3 – Correct orientation of pitman arm =====
-placeholder
+This step shows the correct orientation and alignment of one pitman arm.
 {{:3d_prints:instructions:conventional:9c.jpg?700}}
@@ Line 29: / Line 41: @@
 -----
-===== Step 9.4 –  =====
+===== Step 9.4 – Place pitman arm pins =====
-placeholder
+Insert one pitman arm pin in each socket.
 {{:3d_prints:instructions:conventional:9d.jpg?700}}
@@ Line 37: / Line 49: @@
 -----
-===== Step 9.4 –  =====
+===== Step 9.5 – Part completion =====
-placeholder
+Push the pins in until they are flush.
 {{:3d_prints:instructions:conventional:9e.jpg?700}}
 -----
+<WRAP group>
+<WRAP quarter column>
 [[3d_prints:instructions:conventional:step8|⬅ Previous Step]]
-|
+</WRAP>
+<WRAP right quarter column>
 [[3d_prints:instructions:conventional:step10|Next Step ➜]]
+</WRAP>
+</WRAP>