Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step8 [2026/03/12 22:50] – unexpectedlee
+++ 3d_prints:instructions:conventional:step8 [2026/03/13 22:51] (current) – unexpectedlee
@@ Line 1: / Line 1: @@
 ====== Step 8 – Install Walking Beam  ======
-<WRAP box>
+<WRAP info>
-placeholder
+New Parts needed for this step:
+  - Saddle bearing pin
 </WRAP>
-===== Step 8.1 –   =====
-placeholder
+===== Step 8.1 – Identify the part  =====
+The saddle bearing pin is smaller than the equalizer pin but larger than the two equalizer arm pins.
 {{:3d_prints:instructions:conventional:8a.jpg?700}}
@@ Line 13: / Line 15: @@
 -----
-===== Step 8.2 –  =====
+===== Step 8.2 – Walking beam install =====
-placeholder
+Place the walking beam on the saddle bearing.  Insert the saddle bearing pin.
 {{:3d_prints:instructions:conventional:8b.jpg?700}}
@@ Line 21: / Line 23: @@
 -----
-===== Step 8.3 –  =====
+===== Step 8.3 – Completed step =====
-placeholder
+The saddle bearing pin should be centered in the saddle bearing.
 {{:3d_prints:instructions:conventional:8c.jpg?700}}