Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step7 [2026/03/12 22:50] – unexpectedlee
+++ 3d_prints:instructions:conventional:step7 [2026/03/13 22:47] (current) – unexpectedlee
@@ Line 1: / Line 1: @@
 ====== Step 7 – Install Horsehead  ======
-<WRAP box>
+<WRAP info>
-placeholder
+New Parts needed for this step:
+  - Horsehead
+  - Walking Beam
 </WRAP>
-===== Step 7.1 –   =====
-placeholder
+===== Step 7.1 – Identify parts  =====
+The horsehead is on the left and walking beam on the right.
 {{:3d_prints:instructions:conventional:7a.jpg?700}}
@@ Line 13: / Line 16: @@
 -----
-===== Step 7.2 –  =====
+===== Step 7.2 – Horsehead Alignment =====
-placeholder
+Position the horsehead as shown on the walking beam.
 {{:3d_prints:instructions:conventional:7b.jpg?700}}
@@ Line 21: / Line 24: @@
 -----
-===== Step 7.3 –  =====
+===== Step 7.3 – Slide Horsehead into position =====
-placeholder
+Slide the horsehead onto the walking beam.
 {{:3d_prints:instructions:conventional:7c.jpg?700}}