3d_prints:instructions:conventional:step6
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| 3d_prints:instructions:conventional:step6 [2026/03/13 22:45] – unexpectedlee | 3d_prints:instructions:conventional:step6 [2026/03/14 22:00] (current) – [Step 6.2 – Insert the front posts] unexpectedlee | ||
|---|---|---|---|
| Line 26: | Line 26: | ||
| From the front of the unit, the arrows will be visible and point towards each other. | From the front of the unit, the arrows will be visible and point towards each other. | ||
| - | < | + | < |
| When inserting the posts, hold them firmly as low as possible while inserting them. Torquing them in any horizontal direction can cause them to break. | When inserting the posts, hold them firmly as low as possible while inserting them. Torquing them in any horizontal direction can cause them to break. | ||
| </ | </ | ||
3d_prints/instructions/conventional/step6.1773441917.txt.gz · Last modified: by unexpectedlee