3d_prints:instructions:conventional:step5
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| 3d_prints:instructions:conventional:step5 [2026/03/13 22:35] – unexpectedlee | 3d_prints:instructions:conventional:step5 [2026/03/14 21:59] (current) – [Step 5.6 – Fully position the motor platform] unexpectedlee | ||
|---|---|---|---|
| Line 41: | Line 41: | ||
| Insert the platform legs into the small sockets at the bottom rear of the base. Align the legs as shown. | Insert the platform legs into the small sockets at the bottom rear of the base. Align the legs as shown. | ||
| - | < | + | < |
| If you put the legs in the wrong position, be careful to pull them directly backwards so as not to break one. | If you put the legs in the wrong position, be careful to pull them directly backwards so as not to break one. | ||
| </ | </ | ||
| Line 61: | Line 61: | ||
| Slide the motor platform forward and down until it is inserted fully. | Slide the motor platform forward and down until it is inserted fully. | ||
| - | < | + | < |
| Be careful not to apply too much pressure in any one direction. | Be careful not to apply too much pressure in any one direction. | ||
| </ | </ | ||
3d_prints/instructions/conventional/step5.1773441343.txt.gz · Last modified: by unexpectedlee