Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step4 [2026/03/13 22:25] – [Step 4.11 – Correctly position the key] unexpectedlee
+++ 3d_prints:instructions:conventional:step4 [2026/03/13 22:26] (current) – [Step 4.11 – Correctly position the key] unexpectedlee
@@ Line 102: / Line 102: @@
 -----
-===== Step 4.10 – Align the key way =====
+===== Step 4.10 – Correctly position the key =====
-Rotate the gears to align the key way if it is not already aligned.
+Slide the shaft until the key is centered in the gear.
 {{:3d_prints:instructions:conventional:4j.jpg?700}}
@@ Line 110: / Line 110: @@
 -----
-===== Step 4.11 – Correctly position the key =====
+===== Step 4.11 – View of completed gearbox =====