Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step4 [2026/03/13 22:24] – [Step 4.10 – Align the key way] unexpectedlee
+++ 3d_prints:instructions:conventional:step4 [2026/03/13 22:26] (current) – [Step 4.11 – Correctly position the key] unexpectedlee
@@ Line 82: / Line 82: @@
 -----
-===== Step 4.8 – Weight shaft installation =====
+===== Step 4.8 – Align the key way =====
 The weight shaft key has a rounded and flat side.  The flat side goes into the weight shaft keyhole.
@@ Line 96: / Line 96: @@
 ===== Step 4.9 – Install weight shaft key =====
+Rotate the gears to align the key way if it is not already aligned.
 {{:3d_prints:instructions:conventional:4i.jpg?700}}
@@ Line 102: / Line 102: @@
 -----
-===== Step 4.10 – Align the key way =====
+===== Step 4.10 – Correctly position the key =====
+Slide the shaft until the key is centered in the gear.
 {{:3d_prints:instructions:conventional:4j.jpg?700}}
@@ Line 110: / Line 110: @@
 -----
-===== Step 4.11 – Correctly position the key =====
+===== Step 4.11 – View of completed gearbox =====
-Slide the shaft until the key is centered in the gear.
 {{:3d_prints:instructions:conventional:4k.jpg?700}}