3d_prints:instructions:conventional:step2
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| 3d_prints:instructions:conventional:step2 [2026/03/13 22:00] – unexpectedlee | 3d_prints:instructions:conventional:step2 [2026/03/13 22:03] (current) – unexpectedlee | ||
|---|---|---|---|
| Line 6: | Line 6: | ||
| </ | </ | ||
| - | ===== Step 2.1 – | + | ===== Step 2.1 – Position the reducer assembly |
| In similar fashion as the gearbox, place the reducer assembly directly onto the base. | In similar fashion as the gearbox, place the reducer assembly directly onto the base. | ||
| Line 14: | Line 14: | ||
| ----- | ----- | ||
| - | ===== Step 2.2 – ===== | + | ===== Step 2.2 – Align the guide rails ===== |
| Ensure the reducer assembly aligns with the base channels. | Ensure the reducer assembly aligns with the base channels. | ||
| Line 27: | Line 27: | ||
| <WRAP tip> | <WRAP tip> | ||
| - | A slight amount of pressure pushing upwards from the base will help the reducer assembly slide. | + | A slight amount of pressure pushing upwards from the underside of the base will help the reducer assembly slide. |
| </ | </ | ||
3d_prints/instructions/conventional/step2.1773439242.txt.gz · Last modified: by unexpectedlee