Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step2 [2026/03/12 23:06] – unexpectedlee
+++ 3d_prints:instructions:conventional:step2 [2026/03/13 22:03] (current) – unexpectedlee
@@ Line 6: / Line 6: @@
 </WRAP>
-===== Step 2.1 –   =====
+===== Step 2.1 – Position the reducer assembly  =====
 In similar fashion as the gearbox, place the reducer assembly directly onto the base.
@@ Line 14: / Line 14: @@
 -----
-===== Step 2.2 –  =====
+===== Step 2.2 – Align the guide rails =====
 Ensure the reducer assembly aligns with the base channels.
@@ Line 22: / Line 22: @@
 -----
-===== Step 2.3 –  =====
+===== Step 2.3 – Slide to Lock =====
 Push the reducer assembly **straight to the right** until it locks into place.
+<WRAP tip>
+A slight amount of pressure pushing upwards from the underside of the base will help the reducer assembly slide.
+</WRAP>
 {{:3d_prints:instructions:conventional:2c.jpg?700}}