Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step2 [2026/03/12 23:03] – unexpectedlee
+++ 3d_prints:instructions:conventional:step2 [2026/03/13 22:03] (current) – unexpectedlee
@@ Line 6: / Line 6: @@
 </WRAP>
-===== Step 2.1 –   =====
+===== Step 2.1 – Position the reducer assembly  =====
-placeholder
+In similar fashion as the gearbox, place the reducer assembly directly onto the base.
 {{:3d_prints:instructions:conventional:2a.jpg?700}}
@@ Line 14: / Line 14: @@
 -----
-===== Step 2.2 –  =====
+===== Step 2.2 – Align the guide rails =====
-placeholder
+Ensure the reducer assembly aligns with the base channels.
 {{:3d_prints:instructions:conventional:2b.jpg?700}}
@@ Line 22: / Line 22: @@
 -----
-===== Step 2.3 –  =====
+===== Step 2.3 – Slide to Lock =====
-placeholder
+Push the reducer assembly **straight to the right** until it locks into place.
-{{:3d_prints:instructions:conventional:2c.jpg?700}}
+<WRAP tip>
+A slight amount of pressure pushing upwards from the underside of the base will help the reducer assembly slide.
-<WRAP important>
-placeholder
 </WRAP>
+{{:3d_prints:instructions:conventional:2c.jpg?700}}
 -----