Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step2 [2026/03/10 23:51] – unexpectedlee
+++ 3d_prints:instructions:conventional:step2 [2026/03/13 22:03] (current) – unexpectedlee
@@ Line 1: / Line 1: @@
-====== Step 2 – Install the Reducer Base ======
+====== Step 2 – Install Reducer Base  ======
-<WRAP box>
+<WRAP info>
-Place the reducer base onto the base and slide it to the back until it locks.
+New Parts needed for this step:
+  - Base
 </WRAP>
-===== Step 2.1 – Position the Gearbox =====
+===== Step 2.1 – Position the reducer assembly  =====
-Place the gearbox directly onto the reducer base.
+In similar fashion as the gearbox, place the reducer assembly directly onto the base.
 {{:3d_prints:instructions:conventional:2a.jpg?700}}
@@ Line 13: / Line 14: @@
 -----
-===== Step 2.2 – Align the Guide Rails =====
+===== Step 2.2 – Align the guide rails =====
-Ensure the gearbox rails align with the reducer base channels.
+Ensure the reducer assembly aligns with the base channels.
 {{:3d_prints:instructions:conventional:2b.jpg?700}}
@@ Line 23: / Line 24: @@
 ===== Step 2.3 – Slide to Lock =====
-Push the gearbox **straight to the right** until it locks into place.
+Push the reducer assembly **straight to the right** until it locks into place.
-{{:3d_prints:instructions:conventional:2c.jpg?700}}
+<WRAP tip>
+A slight amount of pressure pushing upwards from the underside of the base will help the reducer assembly slide.
-<WRAP important>
-Do not twist the gearbox while installing.
 </WRAP>
------
+{{:3d_prints:instructions:conventional:2c.jpg?700}}
+-----
+<WRAP group>
+<WRAP quarter column>
 [[3d_prints:instructions:conventional:step1|⬅ Previous Step]]
-|
+</WRAP>
+<WRAP right quarter column>
 [[3d_prints:instructions:conventional:step3|Next Step ➜]]
+</WRAP>
+</WRAP>