Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step15 [2026/03/12 01:33] – created unexpectedlee
+++ 3d_prints:instructions:conventional:step15 [2026/03/14 21:40] (current) – unexpectedlee
@@ Line 1: / Line 1: @@
 ====== Step 15 – Install Belts  ======
-<WRAP box>
+<WRAP info>
-placeholder
+New Parts needed for this step:
+  - Belts (2)
 </WRAP>
-===== Step 15.1 –   =====
+===== Step 15.1 – Install both belts =====
-placeholder
+Install both belts in the groves on the gearbox pulley.
 {{:3d_prints:instructions:conventional:15a.jpg?700}}
@@ Line 13: / Line 14: @@
 -----
-===== Step 15.2 –  =====
+===== Step 15.2 – Connect belt to motor pulley =====
-placeholder
+Stretch the back pulley to and over the motor pulley.  It should go in the back grove.
 {{:3d_prints:instructions:conventional:15b.jpg?700}}
@@ Line 21: / Line 22: @@
 -----
-===== Step 15.3 –  =====
+===== Step 15.3 – Connect 2nd belt =====
-placeholder
+Repeat to install the 2nd belt.
 {{:3d_prints:instructions:conventional:15c.jpg?700}}
 -----
+<WRAP group>
+<WRAP quarter column>
 [[3d_prints:instructions:conventional:step14|⬅ Previous Step]]
-|
+</WRAP>
+<WRAP right quarter column>
 [[3d_prints:instructions:conventional:step16|Next Step ➜]]
+</WRAP>
+</WRAP>