Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step14 [2026/03/12 01:32] – created unexpectedlee
+++ 3d_prints:instructions:conventional:step14 [2026/03/14 21:38] (current) – unexpectedlee
@@ Line 1: / Line 1: @@
 ====== Step 14 – Install Motor Shaft  ======
-<WRAP box>
+<WRAP info>
-placeholder
+New Parts needed for this step:
+  - Motor Pulley
+  - Motor Shaft
+  - Hand Wheel
 </WRAP>
-===== Step 14.1 –   =====
+===== Step 14.1 – Identify parts =====
-placeholder
+Parts from left to right are:  Motor Pulley, Motor Shaft, and Hand Wheel.
 {{:3d_prints:instructions:conventional:14a.jpg?700}}
@@ Line 13: / Line 16: @@
 -----
-===== Step 14.2 –  =====
+===== Step 14.2 – Insert motor shaft =====
-placeholder
+Insert the motor shaft as shown.  The retaining ring should be on the right side.
 {{:3d_prints:instructions:conventional:14b.jpg?700}}
@@ Line 21: / Line 24: @@
 -----
-===== Step 14.2 –  =====
+===== Step 14.3 – Install pulley =====
-placeholder
+Install the pulley as shown.
 {{:3d_prints:instructions:conventional:14c.jpg?700}}
@@ Line 29: / Line 32: @@
 -----
-===== Step 14.2 –  =====
+===== Step 14.4 – Install hand wheel =====
-placeholder
+Install the handwheel as shown.
 {{:3d_prints:instructions:conventional:14d.jpg?700}}
 -----
+<WRAP group>
+<WRAP quarter column>
 [[3d_prints:instructions:conventional:step13|⬅ Previous Step]]
-|
+</WRAP>
+<WRAP right quarter column>
 [[3d_prints:instructions:conventional:step15|Next Step ➜]]
+</WRAP>
+</WRAP>