Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step13 [2026/03/12 22:51] – [Step 13.2 –] unexpectedlee
+++ 3d_prints:instructions:conventional:step13 [2026/03/14 21:34] (current) – unexpectedlee
@@ Line 1: / Line 1: @@
 ====== Step 13 – Install Wrist Pin  ======
-<WRAP box>
+<WRAP info>
-placeholder
+New Parts needed for this step:
+  - Crank Pin (2)
 </WRAP>
-===== Step 13.1 –   =====
+===== Step 13.1 – Align crank and pitman arm =====
-placeholder
+Rotate the crank and/or pitman arm to align the socket.
 {{:3d_prints:instructions:conventional:13a.jpg?700}}
@@ Line 13: / Line 14: @@
 -----
-===== Step 13.2 –  =====
+===== Step 13.2 – Insert crank pins =====
-placeholder
+Rotate the crank pin through the pitman arm into the crank.  You will likely need to rotate the crank pin until it fits into the crank socket.
+<WRAP tip>
+Once both crank pins are installed, the weights and pitman should be able to rotate fairly easily.
+</WRAP>
 -----