Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step12 [2026/03/14 17:25] – unexpectedlee
+++ 3d_prints:instructions:conventional:step12 [2026/03/14 17:27] (current) – [Step 12.2 – Proper install] unexpectedlee
@@ Line 17: / Line 17: @@
 Once installed, the cranks should rotate downwards.  Thanks gravity.
+<WRAP tip>
+If the cranks do not rotate freely, check to ensure no gears are interlocked.  Also ensure the weight shaft key is still centered in the weight gear.  Until all pieces are installed, some have a tendency to shift out of alignment.
+</WRAP>
 {{:3d_prints:instructions:conventional:12b.jpg?700}}