Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step12 [2026/03/12 01:29] – created unexpectedlee
+++ 3d_prints:instructions:conventional:step12 [2026/03/14 17:27] (current) – [Step 12.2 – Proper install] unexpectedlee
@@ Line 1: / Line 1: @@
 ====== Step 12 – Install Crank Arms  ======
-<WRAP box>
+<WRAP info>
-placeholder
+New Parts needed for this step:
+  - Crank assemblies
 </WRAP>
-===== Step 12.1 –   =====
+===== Step 12.1 – Crank alignment =====
-placeholder
+Each crank has a slotted socket at one end.  The cranks are installed on the crank gear shaft using this socket.
 {{:3d_prints:instructions:conventional:12a.jpg?700}}
@@ Line 13: / Line 14: @@
 -----
-===== Step 12.2 –  =====
+===== Step 12.2 – Proper install =====
-placeholder
+Once installed, the cranks should rotate downwards.  Thanks gravity.
+<WRAP tip>
+If the cranks do not rotate freely, check to ensure no gears are interlocked.  Also ensure the weight shaft key is still centered in the weight gear.  Until all pieces are installed, some have a tendency to shift out of alignment.
+</WRAP>
 {{:3d_prints:instructions:conventional:12b.jpg?700}}
 -----
+<WRAP group>
+<WRAP quarter column>
 [[3d_prints:instructions:conventional:step11|⬅ Previous Step]]
-|
+</WRAP>
+<WRAP right quarter column>
 [[3d_prints:instructions:conventional:step13|Next Step ➜]]
+</WRAP>
+</WRAP>