Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step11 [2026/03/12 22:51] – [Step 11.3 –] unexpectedlee
+++ 3d_prints:instructions:conventional:step11 [2026/03/14 17:22] (current) – unexpectedlee
@@ Line 1: / Line 1: @@
 ====== Step 11 – Install Weights  ======
-<WRAP box>
+<WRAP info>
-placeholder
+New Parts needed for this step:
+  - Crank (2)
+  - Weights (4)
 </WRAP>
-===== Step 11.1 –   =====
+===== Step 11.1 – Identify parts =====
-placeholder
+There are two cranks shown, each flanked by a weight on each side.
+<WRAP tip>
+As concerns this step, the weights and cranks are bidirectional.
+</WRAP>
 {{:3d_prints:instructions:conventional:11a.jpg?700}}
@@ Line 13: / Line 19: @@
 -----
-===== Step 11.2 –  =====
+===== Step 11.2 – Insert weights =====
-placeholder
+Insert one weight on each crank side.
 {{:3d_prints:instructions:conventional:11b.jpg?700}}
@@ Line 21: / Line 27: @@
 -----
-===== Step 11.3 –  =====
+===== Step 11.3 – Fully insert weights =====
-placeholder
+Fully insert the weights into each crank.
+<WRAP info>
+Weights are adjustable.  Though not critical in the model, they are very important in balancing the unit.  If the weights are not installed far enough onto the crank, as in real life, they will strike the ground.
+</WRAP>
 {{:3d_prints:instructions:conventional:11c.jpg?700}}