Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step10 [2026/03/12 01:28] – created unexpectedlee
+++ 3d_prints:instructions:conventional:step10 [2026/03/14 17:18] (current) – [Step 10 – Install Equalizer Beam] unexpectedlee
@@ Line 1: / Line 1: @@
 ====== Step 10 – Install Equalizer Beam  ======
-<WRAP box>
+<WRAP info>
-placeholder
+New Parts needed for this step:
+  - Equalizer Pin
 </WRAP>
-===== Step 10.1 –   =====
+===== Step 10.1 – Part identification =====
-placeholder
+The equalize pin is the last pin remaining.
 {{:3d_prints:instructions:conventional:10a.jpg?700}}
@@ Line 13: / Line 14: @@
 -----
-===== Step 10.2 –  =====
+===== Step 10.2 – Align tail bearing =====
-placeholder
+Align the equalizer and tail bearing as shown.
 {{:3d_prints:instructions:conventional:10b.jpg?700}}
@@ Line 21: / Line 22: @@
 -----
-===== Step 10.3 –  =====
+===== Step 10.3 – Pin Install =====
-placeholder
+Insert the equalize pin as shown.
 {{:3d_prints:instructions:conventional:10c.jpg?700}}
@@ Line 29: / Line 30: @@
 -----
-===== Step 10.4 –  =====
+===== Step 10.4 – Part completion =====
-placeholder
+Push the pin in until it is centered.
 {{:3d_prints:instructions:conventional:10d.jpg?700}}
 -----
+<WRAP group>
+<WRAP quarter column>
 [[3d_prints:instructions:conventional:step9|⬅ Previous Step]]
-|
+</WRAP>
+<WRAP right quarter column>
 [[3d_prints:instructions:conventional:step11|Next Step ➜]]
+</WRAP>
+</WRAP>