3d_prints:instructions:conventional:step1
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| 3d_prints:instructions:conventional:step1 [2026/03/12 23:00] – unexpectedlee | 3d_prints:instructions:conventional:step1 [2026/03/14 22:07] (current) – unexpectedlee | ||
|---|---|---|---|
| Line 2: | Line 2: | ||
| <WRAP info> | <WRAP info> | ||
| - | <WRAP em>Parts</ | + | New Parts needed for this step: |
| - | Gearbox | + | - Gearbox |
| - | + | - Reducer Base | |
| - | *Reducer Base | + | |
| - | + | ||
| - | - Check beam alignment | + | |
| - | - Verify pitman arms move freely | + | |
| - | - Ensure belt is properly installed | + | |
| </ | </ | ||
| Line 40: | Line 35: | ||
| <WRAP group> | <WRAP group> | ||
| <WRAP quarter column> | <WRAP quarter column> | ||
| - | [[3d_prints: | + | [[3d_prints: |
| </ | </ | ||
3d_prints/instructions/conventional/step1.1773356419.txt.gz · Last modified: by unexpectedlee