3d_prints:instructions:conventional:step1
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| 3d_prints:instructions:conventional:step1 [2026/03/12 22:56] – unexpectedlee | 3d_prints:instructions:conventional:step1 [2026/03/14 22:07] (current) – unexpectedlee | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ====== Step 1 – Install the Gearbox ====== | ====== Step 1 – Install the Gearbox ====== | ||
| - | < | + | < |
| - | Place the gearbox onto the reducer base and slide it to the right until it locks. | + | New Parts needed for this step: |
| + | - Gearbox | ||
| + | - Reducer Base | ||
| </ | </ | ||
| Line 33: | Line 35: | ||
| <WRAP group> | <WRAP group> | ||
| <WRAP quarter column> | <WRAP quarter column> | ||
| - | [[3d_prints: | + | [[3d_prints: |
| </ | </ | ||
3d_prints/instructions/conventional/step1.1773356212.txt.gz · Last modified: by unexpectedlee