Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step1 [2026/03/12 22:55] – [Step 1.2 – Align the Guide Rails] unexpectedlee
+++ 3d_prints:instructions:conventional:step1 [2026/03/14 22:07] (current) – unexpectedlee
@@ Line 1: / Line 1: @@
 ====== Step 1 – Install the Gearbox ======
-<WRAP box>
+<WRAP info>
-Place the gearbox onto the reducer base and slide it to the right until it locks.
+New Parts needed for this step:
+  - Gearbox
+  - Reducer Base
 </WRAP>
@@ Line 16: / Line 18: @@
 Ensure the gearbox rails align with the reducer base channels.
-<WRAP tip>
-Be especially careful sliding the gear box forward.  Horizontal twisting can break the rails.
-</WRAP>
 {{:3d_prints:instructions:conventional:1b.jpg?700}}
@@ Line 27: / Line 26: @@
 Push the gearbox **straight to the right** until it locks into place.
+<WRAP important>
+Be especially careful sliding the gear box.  Horizontal twisting can break the rails.
+</WRAP>
 {{:3d_prints:instructions:conventional:1c.jpg?700}}
@@ Line 33: / Line 35: @@
 <WRAP group>
 <WRAP quarter column>
-[[3d_prints:instructions:conventional:start|⬅ Previous Step]]
+[[3d_prints:instructions:conventional:parts|⬅ Parts]]
 </WRAP>