Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step1 [2026/03/10 23:49] – unexpectedlee
+++ 3d_prints:instructions:conventional:step1 [2026/03/14 22:07] (current) – unexpectedlee
@@ Line 1: / Line 1: @@
 ====== Step 1 – Install the Gearbox ======
-<WRAP box>
+<WRAP info>
-Place the gearbox onto the reducer base and slide it to the right until it locks.
+New Parts needed for this step:
+  - Gearbox
+  - Reducer Base
 </WRAP>
@@ Line 24: / Line 26: @@
 Push the gearbox **straight to the right** until it locks into place.
+<WRAP important>
+Be especially careful sliding the gear box.  Horizontal twisting can break the rails.
+</WRAP>
 {{:3d_prints:instructions:conventional:1c.jpg?700}}
-<WRAP important>
+-----
-Do not twist the gearbox while installing.
+<WRAP group>
+<WRAP quarter column>
+[[3d_prints:instructions:conventional:parts|⬅ Parts]]
 </WRAP>
------
+<WRAP right quarter column>
-[[3d_prints:instructions:conventional:start|⬅ Previous Step]]
-|
 [[3d_prints:instructions:conventional:step2|Next Step ➜]]
+</WRAP>
+</WRAP>