Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:step1 [2026/03/10 23:44] – unexpectedlee
+++ 3d_prints:instructions:conventional:step1 [2026/03/14 22:07] (current) – unexpectedlee
@@ Line 1: / Line 1: @@
 ====== Step 1 – Install the Gearbox ======
-<WRAP box>
+<WRAP info>
-Place the gearbox onto the reducer base and slide it to the right until it locks.
+New Parts needed for this step:
+  - Gearbox
+  - Reducer Base
 </WRAP>
@@ Line 13: / Line 15: @@
 -----
-===== Step 2.2 – Align the Guide Rails =====
+===== Step 1.2 – Align the Guide Rails =====
 Ensure the gearbox rails align with the reducer base channels.
-{{:prints:gearbox_step2.jpg?700}}
+{{:3d_prints:instructions:conventional:1b.jpg?700}}
 -----
-===== Step 2.3 – Slide to Lock =====
+===== Step 1.3 – Slide to Lock =====
 Push the gearbox **straight to the right** until it locks into place.
-{{:prints:gearbox_step3.jpg?700}}
 <WRAP important>
-Do not twist the gearbox while installing.
+Be especially careful sliding the gear box.  Horizontal twisting can break the rails.
 </WRAP>
+{{:3d_prints:instructions:conventional:1c.jpg?700}}
 -----
+<WRAP group>
+<WRAP quarter column>
+[[3d_prints:instructions:conventional:parts|⬅ Parts]]
+</WRAP>
-[[prints:instructions:conventional_pumping_unit:step1_reducer_base|⬅ Previous Step]]
+<WRAP right quarter column>
-|
+[[3d_prints:instructions:conventional:step2|Next Step ➜]]
-[[prints:instructions:conventional_pumping_unit:step3_samson_post|Next Step ➜]]
+</WRAP>
+</WRAP>