3d_prints:instructions:conventional:start
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| 3d_prints:instructions:conventional:start [2026/03/11 00:39] – [Assembly Steps] unexpectedlee | 3d_prints:instructions:conventional:start [2026/03/14 23:33] (current) – unexpectedlee | ||
|---|---|---|---|
| Line 4: | Line 4: | ||
| This guide walks through assembling the conventional pumping unit model. | This guide walks through assembling the conventional pumping unit model. | ||
| + | |||
| + | <WRAP important> | ||
| + | These instructions are still a work in progress. | ||
| + | </ | ||
| + | |||
| <WRAP box> | <WRAP box> | ||
| Estimated Time: 30 minutes | Estimated Time: 30 minutes | ||
| Line 30: | Line 35: | ||
| * [[3d_prints: | * [[3d_prints: | ||
| * [[3d_prints: | * [[3d_prints: | ||
| + | |||
| + | ----- | ||
| + | <WRAP right quarter column> | ||
| + | [[3d_prints: | ||
| + | </ | ||
| + | |||
3d_prints/instructions/conventional/start.1773189550.txt.gz · Last modified: by unexpectedlee