Differences

This shows you the differences between two versions of the page.

--- 3d_prints:instructions:conventional:info [2026/03/14 22:04] – created unexpectedlee
+++ 3d_prints:instructions:conventional:info [2026/03/14 23:29] (current) – unexpectedlee
@@ Line 1: / Line 1: @@
 ====== Conventional Pumping Unit Info ======
-{{:3d_prints:instructions:conventional:16a.jpg?700}}
+<WRAP info>
+Important information you may benefit from knowing before beginning assembly.
+</WRAP>
-This guide walks through assembling the conventional pumping unit model.
+<WRAP info>
-<WRAP box>
+Super glue usage is entirely up to you.  This model was designed to be assembled and disassembled multiple times.  I'll try to add where I feel superglue may be beneficial.
-Estimated Time: 30 minutes
-Required Tools: None
-Optional Tools: Glue
 </WRAP>
-===== Assembly Steps =====
-  * [[3d_prints:instructions:conventional:step1|Step 1 – Install Gearbox]]
+<WRAP info>
-  * [[3d_prints:instructions:conventional:step2|Step 2 – Install Reducer Base]]
+This is not a mass produced, injection molded model.  It is 3D printed.  As a result, it may break instead of bend.  Please assembly and use with caution.
-  * [[3d_prints:instructions:conventional:step3|Step 3 – Install Gears]]
+</WRAP>
-  * [[3d_prints:instructions:conventional:step4|Step 4 – Install Gear & Drive Shafts]]
-  * [[3d_prints:instructions:conventional:step5|Step 5 – Install Motor & Motor Platform]]
-  * [[3d_prints:instructions:conventional:step6|Step 6 – Install Posts]]
-  * [[3d_prints:instructions:conventional:step7|Step 7 – Install Horsehead]]
-  * [[3d_prints:instructions:conventional:step8|Step 8 – Install Walking Beam]]
-  * [[3d_prints:instructions:conventional:step9|Step 9 – Install Pitman Arms]]
-  * [[3d_prints:instructions:conventional:step10|Step 10 – Install Equalizer Beam]]
-  * [[3d_prints:instructions:conventional:step11|Step 11 – Install Weights]]
-  * [[3d_prints:instructions:conventional:step12|Step 12 – Install Crank Arms]]
-  * [[3d_prints:instructions:conventional:step13|Step 13 – Install Wrist Pin ]]
-  * [[3d_prints:instructions:conventional:step14|Step 14 – Install Motor Shaft ]]
-  * [[3d_prints:instructions:conventional:step15|Step 15 – Install Belts ]]
-  * [[3d_prints:instructions:conventional:step16|Step 16 – Completed Unit ]]
-  * [[3d_prints:instructions:conventional:step17|Step 17 – Optional Step: Belt Guard ]]
 -----
-<WRAP right quarter column>
 <WRAP group>
 <WRAP quarter column>